The only requirement we ask is that the volume be more than 25 units. We do this for one reason, per part cost. Anything smaller than 25 units, you (and we) do not see any economies of discounts based upon CNC/programming/tooling/engineering amortization. We will do one off designs, but costs are typically very high and we encourage off the shelf products for smaller quantities. Prototype designs are accepted, but again small quantites are expensive without volume potential.

Several of these units have been or are made in large volumes and would be considered standard
designs, particularly the open architecture units. If you would like more information about any of the units shown here, call us at 1-800-283-3411 to discuss or e-mail us sales@smi4motion.com
Each Unit is identified with a design title for reference and discussion purpose.

If none of these sub-assenblies appear to be correct for your needs, we will be happy to assist in the design phase using Solid Works 3D modeling, or machine and build from your design and you retain ownership. If you would like input in design or cost saving suggestions, call our engineering staff and they will be glad to assist.

SMI can design the units in house, machine the components, supply linear and mechanical compo-
nents with distributor discounts. assemble in house, serialize and test with laser for accuracy and deliver craftsmanship. For quality control & facitily please see our facility, quality assurnace page.

CNC Machining

Engineering & Technical Support

Machining & Design Capabilities

QC Laser System